Automated Simulation Encryption Nanodevices

Authors

DOI:

https://doi.org/10.18372/1990-5548.77.17960

Keywords:

quantum-dots cellular automata, majority gate, D-type flip-flop, shift nanoregister

Abstract

This article implements the method of automated simulation and design of new non-radiating nanoelectronic encryption modules. Currently, cryptographic equipment is practically not protected from electromagnetic attacks and information decryption, as it is created according to outdated complementary metal-oxide-semiconductor microtechnology. To increase the error-free operation of encryption devices, the article uses a system of automated design of nanodevices based on quantum cellular automata using majoritarian principles of their operation. Automated simulation proved that the consuption of the nanodevices developed in the work does not exceed 3,8´10-23 J. Therefore, unmanned aerial vehicles equipped with the nanodevices developed in the article are completely protected from electromagnetic attacks. The results of automated modeling and verification using a computer design system QCADesigne fully confirmed the effectiveness of introducing single-electron nanodevices into encryption devices of unmanned systems. The proposed logic takes advantage of low power consumption quantum-dot cellular automata together with complicated clocking circuits as a paradigm of nanotechnology advances in encryption engineering.

Author Biographies

Oleksandr Melnyk , National Aviation University, Kyiv, Ukraine

Candidate of Sciences (Engineering)

Associated Professor

Department of Electronics, Robotics, Monitoring & IoT Technologies

Viktoriia Kozarevych , National Aviation University, Kyiv, Ukraine

Senior Lecturer

Department of Electronics, Robotics, Monitoring & IoT Technologies

References

E. Ramini, S. M. Nejad. Secure clocked QCA logic for implementation of cryptographic processors. 2009 applies Electronics, Pilsen 9-10. September, 2009.

C. S. Lent and P. D. Tougaw, “A Device architecture for computing with quantum dots”, Proc. of the IEEE, 1997. https://doi.org/10.1109/5.573740

K. Walus, QCADesiner: A CAD Tool for an Emerging Nano-Technology, Micronet Annual Workshop, 2003.

N. I. Pakulov, V. F. Ukhanov, and P. N. Chernyshov, Mazhoritarnyy printsip postroyeniya nadezhnykh uzlov i ustroystv TSVM, Moskva: Sov. radio, 1974, 184 p. [in Russian]

V. A. Luzhetskyi and O. V. Dmytryshyn, “Alternative modes of block encryption,” Scientific works of VNTU, no. 1, pp. 1–9, 2011. [in Ukraine].

E. Brier, Th. Peyrin and J. Stern, BPS: a format-preserving encryption proposal, 11 p. Resource access mode: http://csrc.nist.gov/groups/ST/toolkit/ BCM/documents/proposedmodes/bps/bps-spec.pdf.

M. Bellare, Ph. Rogaway and T. Spies, “The FFX Mode of Operation for Format-Preserving Encryption,” Draft 1.1. February 20, 2010, 18 p. Resource access mode: http://csrc.nist.gov/groups/ST/toolkit/BCM documents/proposedmodes/ffx/ffx-spec.pdf.

O. V. Dmytryshyn and V. A. Luzhetskyi, “The mode of controlled coupling of encrypted text blocks,” Visnyk VPI, Vinnytsia, Vinnytsia National University Publishing House, no. 1, pp. 34–36, 2009. [in Ukraine].

V. A. Luzhetskyi and O. V. Dmytryshyn, "Procedures for developing keys for block ciphers based on arithmetic operations by modulo,” Information technologies and computer engineering, Vinnytsia, Vinnytsia National University Publishing House, no. 2, pp. 69–74, 2009. [in Ukraine].

I. D. Gorbenko, G. M. Gulak and others, “Analysis of the properties of block symmetric encryption algorithms (based on the results of the international NESIE project),” Radiotechnique: Vseukr. interdisciplinary scientific and technical Sat., Kharkiv: KHNURE, no. 141, pp. 7–24, 2005. [in Ukraine].

Downloads

Published

2023-09-27

Issue

Vol. 3 No. 77 (2023)

Section

AUTOMATION AND COMPUTER-INTEGRATED TECHNOLOGIES

License

Authors who publish with this journal agree to the following terms:

Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).