DESIGN OF VIBRATION AND NOISE CONTROL SYSTEM FOR FLEXIBLE STRUCTURES

Authors

  • В. Макаренко National Aviation University

DOI:

https://doi.org/10.18372/2306-1472.50.115

Keywords:

control system, flexible, noise, structure pattern search, vibration

Abstract

In the article the control system is created, which is able to reduce steady-state vibration response of thinwalled flexible structure in the wide band of low frequencies. It is supposed, that the flexible structure is subject to external harmonic force with variable frequencies, and parameters of that force are available for the usage by the control system. The control system is based on pattern search algorithm and suggestion about the dependence of signal, which is formed by the control system, from the steady-state vibration response of the flexible structure. Developed software allows to use pattern search algorithm as the control system for plate vibration in real-time. The influence on control system operation of signal delay of executive device of compensating path and transition process after the change of control signal parameters is done by the usage of the additional idle time. During idle time the control signal is supported. It has parameters that have taken place before the beginning of idle mode. Step reset option for resuming of search after the long-term steady-state vibration of flexible structure do not derange control system operation, because step change take place only after polling cycle termination. The efficiency of proposed system is illustrated experimentally on the example of clamped plate. Experimental results analysis showed the necessity of multiple compensating devices application for vibration reduction in wide frequency range.

References

Jian-Da, Wu; Rong-Jun, Chen. 2004. –

Application of an active controller for reducing

small-amplitude vertical vibration in a vehicle

seat. – Journal of Sound and Vibration.

Vol. 274: P. 939–951.

Tokhi, M. O., Hossain, M. A. 1994. Selftuning

active vibration control in flexible beam

structures. – Proceedings of Institution of

Mechanical Engineers. Vol. 208: P. 263–278.

Jing, Yuan. 2006. Orthogonal adaptation

for active noise control. – JASA. Vol. 120,

N 1: P. 204–210.

Hanson, C.H., Snyder, S.D. 1997.

Active Control of Noise and Vibration. – Spon.

p.

Yoshiharu, Nakaji; Shigeki, Satoh;

Takeshi, Kimura. 1999. Development of an

active control engine mount system. – Vehicle

System Dynamics. Vol. 32: Р. 185–198,

Макаренко В.М. Моделювання та

управління віброакустичним випроміню-

ванням однорідної пластини під дією

зовнішніх концентрованих сил / В.М. Ма-

каренко // Вісник НАУ. – 2009. – № 3. –

С. 227–237.

Макаренко В.М. Комбінований метод

зниження вібрації та шуму гнучких

конструкцій / В.М. Макаренко // 10-та

Міжнародна науково-технічна конференція

«Авіа-2011». Т.4. – С. 27.8.

Published

17-04-2012

How to Cite

Макаренко, В. (2012). DESIGN OF VIBRATION AND NOISE CONTROL SYSTEM FOR FLEXIBLE STRUCTURES. Proceedings of National Aviation University, 50(1), 74–80. https://doi.org/10.18372/2306-1472.50.115

Issue

Section

AEROSPACE SYSTEMS FOR MONITORING AND CONTROL