USING SOLIDWORKS SIMULATION  AS AN INNOVATIVE TECHNOLOGY WHEN CALCULATING  OF PERFORMANCE OF DETAILS

Oleksandr Rudyk; Mykhailo Poberezhnyi; Pavlo Kaplun; Volodymyr Gonchar

doi:10.18372/2786-5487.1.20256

USING SOLIDWORKS SIMULATION AS AN INNOVATIVE TECHNOLOGY WHEN CALCULATING OF PERFORMANCE OF DETAILS

Authors

Oleksandr Rudyk Khmelnytskyi National University https://orcid.org/0000-0002-6937-1366
Mykhailo Poberezhnyi Khmelnytskyi National University https://orcid.org/0009-0004-6952-1901
Pavlo Kaplun Khmelnytskyi National University https://orcid.org/0000-0002-1675-5104
Volodymyr Gonchar Khmelnytskyi National University https://orcid.org/0000-0002-3719-1408

DOI:

https://doi.org/10.18372/2786-5487.1.20256

Keywords:

SolidWorks Simulation, finite element method, gear block, driven gear, safety factor

Abstract

The method of finite elements based on SolidWorks Simulation was applied to determine the dependence of the minimum coefficient of safety margin of the driven gear of the drum gear block of the vacuum spraying unit UVN-74 on the parameters of the finite element grid.

Downloads

Published

2025-07-27

How to Cite

Rudyk, O., Poberezhnyi, M., Kaplun, P., & Gonchar, V. (2025). USING SOLIDWORKS SIMULATION AS AN INNOVATIVE TECHNOLOGY WHEN CALCULATING OF PERFORMANCE OF DETAILS. Actual Problems in the System of Education: General Secondary Education Institution – Pre-University Training – Higher Education Institution, 1(5), 94–103. https://doi.org/10.18372/2786-5487.1.20256

Download Citation

Issue

No. 5 (2025)

Section

Статті

License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.